Baby Go Round

baby go round, Halloween prop

what you will need:

wood, for the base and spinning platform i used some scrap i had it is 3' in diameter

a ceiling fan, they are cheep

3/4" pvc pipe and fittings

paint,screws,jig saw,

i took the base and connected the ceiling fan to it with some dry wall screws

i cut out a 3' round piece of plywood and also cut a 7" hole in the center for the fan

set the top plywood over the fan, attach the blade hardware to the fan then mount the plywood to the bottom side of the blade holders

i used a 3/4" pvc 3 way fitting fitting which is basically a 90 with a kick off on one side, build a square and then four corners go down to the platform, if you mark out where they sit and screw 4 pvc caps down to the platform then slide in the frame over the top

you can paint if you choose, i did a memorizing spiral that looks awesome when spinning,

wire in a cord to the motor and add whatever you want to spin

here is the finished prop https://www.youtube.com/watch?v=aWS-G-15j3o