Knex Airsoft Bb Holder

its light and compact holds around 16 bbs it has a latch that you twist to the side to let the bbs out

1 red rod (2nd largest), 1 rubber band, 1 orange double sided connector,2 y shaped lego hand look alike pieces, 15 purple 1 part one hole connector, 1 1part connector no hole. I tried to describe the best that i could

attach one of the y pieces to one of the sides (its best if u do it like the pic)

then slide the orange piece through the hole on the rod this will be the mechanism that will let the bbs out when u turn it to the side. (the orange piece is next to the y piece)

now attach all 15 one connection pieces to the rod. (opposite way of the first y piece, next to the orange piece) as shown in the picture

now attach the other y shaped piece to the no hole one connection piece. as shown it the picture. this will stop the bbs from coming out of the back of the holder.

attach the piece u made in step 4 to the end of the holder next to the 15 connectors as shown. make sure this piece covers the hole of the connector at the end so it will block the bbs from coming out. and make sure its opposite from the y piece at the other end.

all you have to do is take the rubberband and put it around the holder make sur that it is closest to the rod as you can get it as shown

easy,trn the orange piece and drop the bbs in,then when u let go of the orange piece it should go back into place and the bbs should not fall out. this is my first instructable, so i hope this will be useful if u have questions plz comment