The Good Samaratin Gun

hellboy 2, the good samaratin gun

-a thick piece of wood
-jigsaw
-misc hardware (small hinges)
-paint
-screwdriver
-drill
-sandpaper
-clamps (optional)
-wood puddy/filler (optional)
-wood glue
-varnish (optional)
-screws

find an image of the gun on the internet and draw it on to wood now cut out those pieces and makes sure its your size

now cut like so

sand down the handle so its very smooth and then sand it even more.

now get a small hinge a locking thingy and an L shaped thingy and place them as shown in picture four when your done this clamp down your gun onto a table and drill a big hole in the tip or two (pic 5)
but if clamps are not available then sak someone to hold it tightly but dont go more than an inch deep

now measure the space inside your gun where the barrel will go make sure that when you make the barrel you make it a little smaller before cuting you can place wood puddy on your gun if you want, just to make it chunkyier once you cut out the circles it should like like picture 1 and 2

the pics with puddy is pics 3 and 4

p.s it takes fifteen muinets for wood puddy to dry

when you have your circles glue them all together it should like so

if it does not fit the sand it down until it does

when it does put in thew barrel with a screw and drill holes

find something that fits in those holes and use them as bullets (i used a pencil

Now paint or stain your gun the color you want it

i painted mine black with a redish brown handle and varnished the handle but not the black parts

for my bullets i painted them copper with a gold tip but if you dont have these paints you can spraypaint or just use different colours

Don`t forget about the chain you can attach it by drilling a small hole near the bottom of the handle and then attaching it in with a screw thingy